Table of Contents
Advertisement
When connecting with IEEE 1394
• The printer must be connected to the IEEE 1394 connector of a computer using the IEEE 1394
interface cable.
• [Activate] is selected in the SCSI print of IEEE 1394 and [Activate] is selected in the Bidi-SCSI print.
• Under Windows XP, [Enable bidirectional support] must be selected and [Enable printer pooling]
must not be selected on the [port] tab with RPCS printer driver.
When connecting with USB
The printer must be connected to the USB connector of a computer using the USB interface cable.
-
- Inactivating the Device
-
-
If you do not want to install the printer when [Found New Hardware Wizard] starts with an op-
erating system, which supports SCSI print, inactivate the device by following the procedures.
• Windows XP
A
In the [Found New Hardware Wizard] dialog box, confirm that [This wizard helps you install
software for: Unknown] is displayed, and select [Install from a list on specific location (Ad-
vanced)], and then click [Next>].
B
When the [Please choose your search and installation option.] message appears, remove all
the selections from [Search for the best driver in these locations.], and then click [Next>].
C
When the [The wizard could not find the software on your computer for..] message appears,
click [OK].
D
When the [Cannot Install this Hardware] message appears, select the [Don't prompt again to in-
stall the software] check box, and then click [Finish].
Operating Instructions
Client Reference
115
Advertisement
Table of Contents
