Fuse; Seat Adjustment Lever; Fuel Shut Off Valve; Cutting Height Lever - Husqvarna Z 246 Operator's Manual

Fuse

The 20 amp primary fuse is located on the left hand side of the
machine. It is accessed by tilting the seat forward. The fuse is
a flat pin type used in automobiles.

Seat Adjustment Lever

The seat can be adjusted lengthways. When making
adjustments, the lever under the right side of the seat is pulled
up, after which the seat can be moved backward or forward.

Fuel Shut Off Valve

The fuel shut off valve is located at the right rear of the seat.
The valve is off when the handle tab is turned perpendicular to
the fuel line.
CONTROLS

Cutting Height Lever

To set the deck cutting height, pull the cutting height lever
inwards and move it to the desired height notch.
IMPORTANT INFORMATION Always raise the deck to the
highest position for transport.
IMPORTANT INFORMATION To obtain an even cutting
height, it is important that the air pressure in all tires is 15
psi / 103 kPa / 1 bar.

Bypass Linkages

Transaxle bypass linkages must be engaged when pushing or
pulling the mower. The release levers are located on each side
of the rear of the unit below the rear engine guard. See Moving
Machine By Hand in the Operation section.
WARNING!
the muffler. To prevent burns, the engine should be shut off
and allowed to cool before the bypass linkage levers are
handled.
14
Bypass linkages are located close to