10
4
Connection of the Network Adapter
This chapter describes the physical connection of the S2Konnect N-3010AVB Network Adapter to
a network.
Transmission Distances
The maximum transmission distance for the S2Konnect N-3010AVB 10/100/1000Base-T adapter,
is 100m, you have to use a Category 5 unshielded twisted pair cable or better.
Connection to the Network
Observe the safety instructions given on page 7.
In order to connect the adapter to the network, proceed as follows:
1.
2.
3.
4.
S2Konnect N-3010AVB
If necessary, configure the port on the switch to which the network adapter is to be
connected (also see the switch manual).
If possible, disconnect the switch and the computer from the power supply.
At one end of the cable connect the RJ-45 connector to the port on the switch.
At the other end of the cable connect the connector to the port on the network adapter.
(see figure 2. "Connection of the RJ-45 cable/plug").
The port type (e.g. 1000Base-T) on the network device and that on the switch must be
identical.
Figure 2. Connection of the RJ-45 cable/plug
ACT/LINK
10=OFF
100=GRN
1000=YLW