Changing The Propeller - Jarvis Marine FWCV SERIES Owner's Manual

CHANGING THE PROPELLER

Before doing anything with the propeller, ensure the cables to the battery
are disconnected.
removing the locknut using the special tool supplied. When doing this, take hold of the
propeller to stop it turning. Under no circumstances should you attempt to loosen the
locknut with a hammer or similar tool as this may damage the locknut or shaft – or both.
(F)
Once the locknut is removed, you will be able to slide the propeller off. When putting
the propeller back on, verify there is a proper fi t of the groove and shear pin otherwise
the propeller will not be locked in place. (G)
After using the motor always check and clear any weed or fi shing line that may have
become tangled around the propeller. Next, give the motor a wipe down with warm
water to remove any salt or sand particles and then spray it with fresh water.
(F)
Detaching the propeller is a simple matter of unscrewing and
(G)