Program Flow Chat; Initial Parameter Set Up (Users Set Up) - Skyrc iMax B8+ Instruction Manual

Program flow chat

10

Initial parameter set up (Users set up)

B8+ will be operated with the default value of the essential user settings when it is
connected to a 12V battery for the first time. The screen displays the following
information in sequence and the user can change the value of parameter on each
screen.
When you are willing to alter the parameter value in the program, press
key to make it blink then change the value with
start/enter
stored by pressing key once.
This informs you of its designation.
INC
The screen displays the nominal voltage of lithium
battery. There are three kinds of lithium battery:
LiFe(3.3V), Lilo(3.6V) or LiPo(3.7V). This is very
important so you have to check the battery carefully
and set it up correctly. If it is different from correct
value the battery explode during charge process.
DEC INC
DEC INC
B8+ recognize the cell count of lithium battery
automatically at the beginning of charge or
discharge process to avoid from erroneous setting
by user. But deeply discharged battery can be
perceived incorrectly. To prevent the error, you can
set the time term to verify the cell count by the
DEC INC
processor. Normally, 10 minutes are enough to
perceive the cell count correctly. For the battery of
larger capacity, you may extend the time term. But if
you set the time term to long for the battery of
smaller capacity, the charge or discharge process
can be finished within the time term with the
erroneous cell count. This may cause the fatal result.
If the processor recognizes the cell count incorrectly
at the beginning of charge or discharge process, you
may extend the time. Otherwise, you had better use
with the default value.
Initial parameter set up (Users set up)
start/enter
Inc> or <Dec
key. The value will be
11