Chapter 9 Remote Node Setup; Remote Node Setup; Figure 9-1 Menu 11 Remote Node Setup - ZyXEL Communications ZyWall 100 User Manual
Internet security gateway
Hide thumbs
Also See for ZyWall 100:
- Quick start manual (13 pages) ,
- Read me first (5 pages) ,
- Brochure & specs (2 pages)
Table of Contents
Advertisement
A remote node is required for placing calls to a remote gateway. A remote node represents both the remote
gateway and the network behind it across a WAN connection. Note that when you use menu 4 to set up
Internet access, you are actually configuring a remote node. The following describes how to configure
Menu 11.1 Remote Node Profile, Menu 11.3 - Remote Node Network Layer Options and Menu 11.5 -
Remote Node Filter.
9.1
Remote Node Setup
From the main menu, select menu option 11 to open Menu 11 Remote Node Setup (shown below).
Then enter 1 to open Menu 11.1 Remote Node Profile and configure the setup for your regular ISP. Enter
2 to open Menu 11.1 Remote Node Profile (Backup ISP) and configure the setup for your Dial Backup
port connection (see the Backup Remote Node Setup chapter).
Remote Node Setup
This chapter shows you how to configure a remote node.
Menu 11 - Remote Node Setup
1. ChangeMe (ISP, SUA)
2. ________
Enter Node # to Edit:
Figure 9-1 Menu 11 Remote Node Setup
ZyWALL 100 Internet Security Gateway
Remote Node Setup
Chapter 9
9-1
Advertisement
Table of Contents
Troubleshooting
