Multimedia ip board casting system, network based full-duplex distribution system! multimedia ip broadcasting system! system audio controller, control video server, system set-top box system monitor, system digital amplifier, pre-amplifier, sistem remote (6 pages)
Page 2
A personal welcome to you from the management and employees of Inter-M All of the co-workers here at Inter-M are dedicated to providing excellent products with inherently good value, and we are delighted you have purchased one of our products.
Precautions when setting up your utilization environment .............3 Front Panel ............................4 Rear Panel ............................5 Applications ............................7 Fabricate The Cables ........................8 RJ45 Data Protecting Connector (Ethercon) ................8 Block Diagram ..........................9 Specifications ..........................10 Service Procedures............................11 Schematic .............................11 Parts List ............................11 Variations and Options .......................11 Warranty ............................11 PP-100...
PRE AMPLIFIER Unpacking Unpacking Although your PP-100 is neither complicated nor difficult to operate, we recommend you take a few minutes to read this brief manual and familiarize yourself with the important information regarding product features, setup and operation. As with most electronic devices, we strongly recommend you retain the original packaging. In the unlikely event the product must be returned for servicing, the original packaging (or reasonable equivalent) is required.
And it has 4 output interfaces and 6 input interfaces, which is utilized to the grand output amplified in the rear part. Precautions when setting up your utilization environment Precautions when setting up your utilization environment Environment setting up menu of SP-100 is commonly utilized then. PP-100...
It indicates Pre-out levels in each of the channels and lights Green LED for a signal output exceeding a pre set level. 4. FAULT INDICATING LED It indicates an operating status of the communication line and lights Red LED when it happens an abnormality in communication. PP-100...
The interface sets up 4 operations of the Control output in Setup Mode of SI-100. ( It is set up in SI-100.) Setting up operation specification that Control output is on, when one signal of EM,BGM,RM,LOCAL,SCHED,ALL is inputted to CH1 ~CH6. Control output can be set up to 4. PP-100...
Page 8
( MIN : Output mute , MAX : 0dB , Vol 60: -5dB , Vol 70 : 0dB) 7. POWER SWITCH It turns ON/ OFF(stand-by) of PP-100 power. 8. NETWORK INPUT JACK ( LINK IN ) It is the input terminal for digital signals and control signals coming from SI-100.
* Caution : Please fabricate CAT5 CABLE for Direct. RJ45 Data Protecting Connector (Ethercon) RJ45 Data Protecting Connector (Ethercon) *Caution :[Relating to fabrication of protecting connectors] Connector between SI-100 and PP-100 :NE8ME Protecting Connectors are applied in both of the UTP cable ends that are assembled together. PP-100...
PRE AMPLIFIER Block Diagram Block Diagram HEAD AMP LINE XLR JACK DECODER LINK BUFFER EXT IN MICOM BALANCE OUT SMPS EXT OUT LEVEL LED DRIVE VOLUME LED DISPLAY LCD DISPLAY PP-100...
To obtain specific warranty information and available service locations contact Inter-M directly or the authorized Inter-M Distributor for your specific country or region.
Page 16
Inter-M, Ltd. (Korea) began operations in 1983. Since then, Inter-M has grown to become one of the largest manufacturers of professional audio and commercial sound electronics equipment in the world. Inter-M has gained worldwide recognition for its own branded products, as well as private label manufacturing of electronics sold under other names (OEM).
Need help?
Do you have a question about the PP-100 and is the answer not in the manual?
Questions and answers