Handling The Remote Controller - York R91 BGE Owner's Manual

Handling the remote controller

8m
CAUTIONS
• The air conditioner will not operate if curtains, doors or other materials
block the signals from the remote controller to the indoor unit.
• Prevent any liquid from falling into the remote controller. Do not expose
the remote controller to direct sunlight or heat.
• If the infrared signal receiver on the indoor unit is exposed to direct sunlight,
the air conditioner may not function properly. Use curtains to prevent the
sunlight from falling on the receiver.
• If other electrical appliances react to the remote controller, either move
these appliances or consult your local dealer.
Location of the remote controller
• Keep the remote controller where its signals
can reach the receiver of the indoor unit.
(A distance of 8m is allowed.)
• When you select the timer operation, the
remote controller automatically transmits a
signal to the indoor unit at the speci ed time.
• If you keep the remote controller in a position
that hinders proper signal transmission, a time
lag of up to 15 minutes may occur.
Replacing batteries
The remote controller uses two alkaline
dry batteries (R03/LR03X2).
(1) Slide the cover of the battery
compartment o according to the
arrow direction, then replace the old
batteries with new ones.
(2) Insert the new batteries making sure
that the (+) and (-) of battery are
installed correctly.
(3) Reattach the cover by sliding it back
into position.
Remark :
- Potential e ect of substances used in
batteries on health and the environment
- Not disposing of batteries with other waste
4