AEG FAVORIT 65040 I User Manual page 31

Problem
The appliance does
not fill with water.
The appliance does
not drain the water.
After the checks are completed, activate
the appliance. The programme contin-
ues from the point of interruption.
If the problem occurs again, contact the
Service.
If the display shows other alarm codes,
contact the Service.
10.1 If the washing and drying
results are not satisfactory
Whitish streaks or bluish layers on
glasses and dishes
• The released quantity of rinse aid is
too much. Adjust the rinse aid selector
to a lower position.
• The quantity of detergent is too much.
Stains and dry water drops on glasses
and dishes
• The released quantity of rinse aid is
not sufficient. Adjust the rinse aid se-
lector to a higher position.
• The quality of the detergent can be
the cause.
Possible cause
You did not press Start.
The fuse in the fuse box is
damaged.
The delay start is set.
The water tap is closed.
The water pressure is too
low.
The water tap is clogged or
there is limescale on it.
The filter in the water inlet
hose is clogged.
The water inlet hose has a
kink or a bend.
The anti-flood device is on.
There are water leakages in
the appliance.
The sink spigot is clogged.
The water drain hose has a
kink or a bend.
Possible solution
Press Start.
Replace the fuse.
Cancel the delay start or
wait for the end of the
countdown.
Open the water tap.
Contact your local water
authority.
Clean the water tap.
Clean the filter.
Make sure that the position
of the hose is correct.
Close the water tap and
contact the Service.
Clean the sink spigot.
Make sure that the position
of the hose is correct.
Dishes are wet
• The programme is without a drying
phase or with a low temperature dry-
ing phase.
• The rinse aid dispenser is empty.
• The quality of the rinse aid can be the
cause.
• The quality of the combi detergent
tablets can be the cause. Try a differ-
ent brand or activate the rinse aid dis-
penser and use rinse aid together with
the combi detergent tablets.
Refer to 'HINTS AND TIPS' for
other possible causes.
Activating the rinse aid
dispenser with the multitab
function activated
1. Press the on/off button to activate
the appliance.
ENGLISH
31