Smart Tracker GPS Vehicle Tracker User Manual page 15

vehicle.
Incoming call from non special number will not activate voice monitoring
function.
Note: To realize this function, please set special numbers beforehand.
The SIM card put into the device should be equipped with caller
identification.
7.8 Oil cut-off
7.8 7.8 7.8 Oil Oil cut-off Oil cut-off cut-off
7.8.1 7.8.1. . . . Via Via platform
7.8.1 7.8.1 Via Via platform platform platform
Send oil cut-off command on platform. To make sure the security of vehicle,
tracker can only indicate to cut off oil when GPS is in valid position status, and
the speed is less than 20KM/H or in static. It needs password and platform
account password is needed when sending oil cut off command.
7.8.2. 7.8.2. Via Via SMS SMS
7.8.2. 7.8.2. Via Via SMS SMS
Firstly, you should set a center number. Only center number can send the
command to the device to cut off and restore oil.
The format is:
After the command is carried out, it will reply "Cut off the fuel supply: Success!
Speed:0 Km/h". If the command didn't carry out, it will reply the reason about
fail to carry out.
Note: To ensure the safety of the driver and the car, this command is valid
only under two conditions: the GPS is located; the speed is less than 20km/h.
7.9 Restoring Oil
7.9 7.9 7.9 Restoring Restoring Restoring Oil Oil Oil
7.9.1 7.9.1 7.9.1 7.9.1. . . . Via Via Via Via platform platform platform platform
When the alarm is off, sending recover oil commands manually. Device will
restore oil supplying, and vehicle will work normally again.
Platform account password is needed when sending oil cut off command.
7.9.2 7.9.2 7.9.2. . . . Via 7.9.2 Via Via Via SMS SMS SMS SMS
Only center number can send the command to the device to restore oil.
RELAY,0# RELAY,0#
The format is RELAY,0# RELAY,0#
:
After the command is carried out, it will receive "Restore fuel supply:Success!"
7. 7. 7. 7.10 10 10 Over Over speed speed
10 Over Over speed speed Alarm
When the car is moving over a limited speed in average in a limited time period,
then the device will send over speed alarm SMS to user.
To turn on the over speed function, please send below SMS command:
RELAY,1# RELAY,1#
RELAY,1# RELAY,1#
Alarm Alarm
Alarm