Table of Contents
Advertisement
Maintenance & Care
5. Before you place the cleaned 2-in-1 water tank
back onto the machine, remove the red solution
filter cap (on the base of the machine). Remove
the cap by inserting a coin or a flat head screw
driver into the slot on the top. Turn counter clock
wise and unscrew. Set aside.
a. Remove the white filter by grasping the
post and pulling up and out of the unit.
Rinse the filter under cold water.
NOTE: Be careful not to drop the filter into the
sink or disposal.
b. Replace the white filter back into the
filter area.
NOTE: Make sure the white filter is seated prop-
erly before placing the red solution filter cap.
c. Replace the red solution filter cap and
turn clockwise to tighten.
6. Keeping the 2-in-1 water tank off of the base
of the machine, simply unscrew the floor nozzle
using a Phillips head screwdriver. This can be
rinsed out at the faucet. Then replace back onto
the machine by starting from the bottom of the
nozzle and hooking the tabs into the holes on
the bottom sides of the machine. Secure into
place with the screw.
7. The inside of the end caps by the brush rolls
can be wiped out with a clean paper towel,
or, if a more thorough cleaning is desired, the
end caps can be taken off using a Phillips head
screwdriver and rinsed clean. Replace after
cleaning.
8. Any loose hair or debris can be pulled from
the brush rolls and thrown away. For the most
thorough clean before storage, follow directions
for removal and replacement of the brush rolls
and belts.
9. To clean attachments that may have been used,
remove from hose and rinse under clean, running
water. Dry and replace attachment in the tool
caddy. Clean the hose by suctioning clean water
from the tap. Before replacing, lift end of hose and
stretch out to ensure all water is cleared from hose.
Refer to page 10.
10. After carpet is dry, vacuum again to remove
hair and fuzz.
www.BISSELL.com
14
5c.
Filter
800.237.7691
Solution
Filter Cap
5a.
5b.
6.
Hide quick links:
Advertisement
Table of Contents
