Plug And Play Configuration Subscreen - Intel PD440FX Product Manual

2
Using the BIOS Setup Program
†
VESA Video Power Down
Sets the command issued to your
†
VESA -compliant graphics add-in card when the
computer enters power-managed mode. The
options are:
•
Disabled (the monitor is not under power
management)
•
Standby (minimal power reduction)
•
Suspend (significant power reduction)
•
Sleep (default) (maximum power reduction)
Inactivity Timer
Sets how long (in minutes) the computer must
be inactive before it enters power-managed
mode. The range is 0-255 minutes. The default
is 10 minutes.
Hot Key
Sets the hot key for power-managed mode.
Press the hot key while holding down the <Ctrl>
and <Alt> keys to enter power-managed mode.
All alphabetic keys are valid entries for this field.
32
Auto Start On AC Loss
Specifies whether the power supply should
resume after AC power interruption. The options
are:
•
Disabled
•
Enabled (default)
Plug and Play Configuration
Subscreen
This section describes the options in the Plug
and Play Configuration subscreen.
Configuration Mode
Sets how the BIOS gets information about non-
Plug and Play ISA add-in cards. The options
are:
• •
Use PnP OS (default)
•
Use BIOS Setup
If Use BIOS Setup is selected, specify the IRQ
for each non-Plug and Play ISA add-in card you
install on the motherboard (see page 34,
IRQ 3, 4, 5, 7, 9, 10, 11, 14, 15).