Answering The Phone; Waking Up The Phone - Kyocera K342 User Manual

Using voice features with
hands-free car kits
You can use voice commands to make a phone
call or to answer the phone only if your phone is
connected to a professionally installed Kyocera
hands-free car kit (sold separately).
The following features apply only to
Note:
installed hands-free car kits unless noted.
To shop for hands-free car kits, visit
www.kyocera-wireless.com/store
800-349-4188 (U.S.A. only) or 858-882-1410.

Waking up the phone

If your phone is connected to a Kyocera installed
hands-free car kit, you can use the voice
command to activate the phone to make a
phone call.
To activate the Voice Wake-up setting:
→
• Select
Menu Settings
→
Voice Features Voice Wake-Up
With accessory.
To wake up the phone:
Say " " and listen for a tone.
1. Wake Up
Say " " again until you hear two tones.
2. Wake Up
If the phone does not recognize your
"Wake up" command, see "Training voice
recognition" on page 47.
46
or call
→
→

Answering the phone

If your phone is attached to a hands-free car kit,
you can set it to (1) answer automatically or (2)
answer using a voice command.
Answering automatically
You can set your phone to answer automatically.
This setting also works with the portable
Note:
hands-free car kit.
→
• Select
Menu Settings
→
Auto-Answer After 5 secs
Answering using voice commands
To use a voice command to answer an incoming
call using the installed hands-free car kit, turn
off.
Auto-Answer
→
• Select
Menu Settings
→
Auto-Answer Disabled
To activate the Voice Answer setting:
→
Select
1. Menu Settings
→
Voice Features Voice Answer
Highlight
2. With accessory
→
Select
3. Menu Settings
, then press
Normal Sounds
To answer a call:
When you receive an incoming call, the phone
responds: "Incoming call, answer?" or "Incoming
roam call, answer?" If the caller is recognized as a
contact entry in your phone, then the phone will
say "Incoming call from (Name), answer?"
• Say " " or press any key except
Yes
→ →
Accessories
.
→ →
Accessories
.
→
.
and press .
→ →
Silent Mode
.
.
Voice Commands