Listening To Fm/Am; Changing Fm/Am Tuner Frequency Steps (Asia And General Models Only); Selecting A Frequency For Reception - Yamaha RX-V571 Owner's Manual

CODE SET CODE SET
SOURCE SOURCE RECEIVER RECEIVER
HDMI HDMI
When tuning a radio, select a frequency or a registered station.
1 1 2 2 3 3 4 4
5 5 V- V V AUX V-AUX
A A AV AV
1 1 2 2 3 3 4 4
TUNER
• To tune into the radio station, connect the antenna in advance (p.27).
FM
5 5 6 6
AUDIO AUDIO DOCK DOCK
AM
• When the radio cannot get good reception, adjust the orientation of the antenna.
TUNER
USB USB
FM AM
TUNING
PRESET PRESET TUNING
INFO INFO MEMORY MEMORY
SUR. DECODE SUR. DECODE STRAIGHT STRAIGHT
MOVIE MOVIE MUSIC MUSIC
SLEEP SLEEP ENHANCER ENHANCER DIRECT DIRECT
SCENE SCENE
CD CD RADIO RADIO Changing FM/AM tuner frequency steps
OPTION OPTION
(Asia and General models only)
VOLUME VOLUME
The factory pre-set FM/AM tuner frequency steps are 9 kHz for AM
DISPLAY DISPLAY A A
and 50 kHz for FM. Carry out the following settings and select the
POP-UP POP-UP
MUTE MUTE
MENU MENU
frequency steps suitable for your listening environment.
MODE MODE
1
1 2 3 4
2
Numeric keys
5 6 7 8
9 0 10 10 ENT ENT
TV TV
INPUT INPUT
TV VOL TV VOL TV CH TV CH
MUTE MUTE
3

Listening to FM/AM

• FM/AM tuner frequencies will differ depending on the country or region where
the unit is being used. The explanation of this section uses a display with
frequencies used in U.K. and Europe models.
Switch this unit to the standby mode.
Press while pressing and holding STRAIGHT on
the front panel.
Release the keys when "ADVANCED SETUP" (p.76) is
displayed on the front display.
After approximately a few seconds, the top menu items are
displayed.
YPAO MIC
INFO MEMORY PRESET FM AM
SCENE
A
BD TV CD RADIO
DVD
PHONES USB INPUT TONE CONTROL PROGRAM STRAIGHT
SILENT CINEMA iPod/iPhone
PROGRAM l / h
STRAIGHT
Press PROGRAM repeatedly to display "TU."
ENHANCER iPod CHARGE SLEEP
STEREO
TUNED
TU - AM9/FM50
4
5

Selecting a frequency for reception

1
2
3
T
Press STRAIGHT repeatedly to select one of the
frequency steps.
Switch this unit to the standby mode, and then
switch it on again.
The power turns on, with the settings you made configured.
Press TUNER to select "TUNER" as the input
source.
Press FM or AM to select FM or AM to receive.
VOL.
FM 87.50MHz
Select the frequency with the following keys.
TUNING: Selects a frequency.
Press and hold this key for approximately a second to search
for a station automatically.
Numeric keys: Enter a frequency directly with numbers (For
example, press "9," "8," "5" and "0" to select a station on
98.50 MHz.).
• "Wrong Station!" appears when a frequency is out of receivable range.
VOL.
STEREO
TUNED
FM 98.50MHz
"TUNED" lights up when a broadcast is received from a
station.
"STEREO" lights up when stereo broadcast is received from a
station.
SW
C
L R
SL SR
41
En