Table of Contents
Advertisement
Interface connectors
Important note on the interface connectors
Be sure to turn off printer power before connecting or disconnecting an interface cable to the printer. For
protection against static discharge which may be applied to the printer's internal electronics through the
interface connector(s), keep the optional paper handler/stacker connector (see page 1-6) which is not in use
capped using the protective cap supplied.
Use shielded interface cable.
Safety information
Laser safety
This printer is certified as a Class 1 laser product under the U.S. Department of Health and Human Services
(DHHS) Radiation Performance Standard according to Radiation Control for Health and Safety Act of 1968.
This means that the printer does not produce hazardous laser radiation. Since radiation emitted inside the
printer is completely confined within protective housings and external covers, the laser beam cannot escape
from the printer during any phase of user operation.
Laser notice
This printer is certified in the U.S. to conform to the requirements of DHHS 21 CFR Subchapter for Class I
(1) laser products, and elsewhere is certified as a Class I laser product conforming to the requirements of
IEC 825-1.
Caution
Invisible laser radiation when open. Avoid direct exposure to beam.
Use of controls or adjustments or performance of procedures other than those specified herein may result in
hazardous radiation exposure.
(European/Asian
countries)
(U.S.A./Canada)
Introduction
v
Advertisement
Table of Contents
