Advertisement
2. Setting the chosen polarity for the output plug.
- There is only one engraved marking on the cable socket it is
- But each of the supplied output plugs has two engraved markings, + and – sign just above pins.
3. Double check for polarity and voltage of your portable and adapter setting.
INCORRECT OUTPUT VOLTAGE, POLARITY MAY DAMAGE YOUR PORTABLE
1. DO NOT use this connector if you are not sure of the polarity or voltage of portable.
2. DO NOT use this adapter for portable that consumes more than 3000mA.
3. DO NOT use this adapter while starting the vehicle.
4. DO NOT cover this adapter or put it near any heat source.
E. Connecting the Portables
Before connecting to your portable double check on:
1. The output voltage as display in the middle window of LCD matches your portable's voltage.
2. Make sure the polarity of is correct.
3. Any mismatch of the above 2 important points will or may damage your portable.
F. Using the built in USB power output
The USB output is made to the USB power standard of 5VDC and 0.6A.
You can power up or charge your portables such as iPod, MP3 which have USB power connectors for
getting dc power from PC (Personal Computer).
G. Changing the Backlight Color of LCD
1. First disconnect power to adapter by removing either the cigarette plug or DC-IN
2. Press and hold the preset button and at the same time reconnect power to adapter.
3. When the LCD is lit up again, release the preset button
4. Then quick press on the Preset Button will change the backlight color.
5. When desired color is found, disconnect power to adapter as in 1.
The last appeared color will be the newly selected backlight color.
Safeguarding your battery
This unique function protects your car battery from over-discharged by current draining portables.
You will not be left stranded with a flat battery.
The Micro-Processor keeps on checking the battery voltage and charge state of your car (12V system)
or your truck (24V system).
When it detects your battery drops to a critically low level, the LCD backlight first changes to flashing
red and all outputs (3A DC output and USB) are cut off.
.
Advertisement
