Network settings
Switching between phone lines
Your phone can have two service accounts, or
phone lines, associated with it. Each phone line
has its own phone number.
When you are using one line, you cannot receive
calls from the other. It would be as if the phone
were "off" for that number. Your voicemail,
however, will still take messages. All contacts and
settings are shared for both lines.
You must first establish a second phone
Note:
line with your service provider. Once established,
a second phone number becomes available in the
menu for selection:
→
Select
1.
Menu
Settings
.
Set Phone Line
Select one of the two lines and press
2.
Data Settings
Setting Com port speed
The Com Speed sets the data rate at which your
phone connects to a laptop or PC, or at which it
sends and receives over-the-air text messages.
→
Select
1.
Menu
Settings
.
Com Port Speed
Select the speed. The options are:
2.
(default),
115.2 kbps
User Guide for the Kyocera Slider Jet Phone
→
→
Network
.
→
→
Accessories
19.2 kbps
, and
.
230.4 kbps
Other
There may be a higher charge for making
Note:
calls using high-speed data in areas where 1X
service is available. Check with your service
provider for details.
Setting the phone to receive data
or faxes
Your phone may be able to receive certain data or
faxes, depending on the system sending the
information. You cannot receive voice calls while
the phone is in data/fax mode.
To receive data or faxes, you must connect the
phone to a laptop or PC and switch the phone
from voice mode to data/fax mode.
To purchase a cable, call 800-349-4188
Note:
(U.S.A. only), 858-882-1410, or visit
www.kyocera-wireless.com/store
Connect the phone to the laptop or PC.
1.
Set the Com speed.
2.
Select
3.
Menu
Data/Fax Calls
Scroll through the list and press
4.
an option:
–
Voice only
–
,
Fax
next call
phone to fax mode or data mode for the
next incoming call or the next 10 minutes.
,
–
,
Fax
until off
phone into fax mode or data mode until
the phone is turned off.
.
→
→
Settings
Network
.
allows only voice calls.
or
,
Data
next call
or
,
forces the
Data
until off
→
to select
sets the
51