Numatic NSP 180A Owner's Instructions Manual page 7

Information for DRY USE Vacuum Cleaners
Ensure you read the instruction manual before using the machine.
Operators shall be adequately instructed on the use of these machines, as with all electrical equipment,
care and attention must be exercised at all times during use, you must also make certain that routine and
preventative maintenance is carried out periodically to ensure safe operation.
Failure to carry out maintenance as necessary, including the replacement of parts to the correct standard
could render this equipment unsafe and the manufacturer can accept no responsibility in this respect.
This machine is for DRY USE only
You must disconnected the machine from the mains by removing the plug from the supply socket BEFORE
cleaning or maintenance and when replacing parts or converting the machine to another function.
This appliance is intended to be assembled, cleaned and maintained by an adult.
This machine is not suitable for the collection of biological hazards, hazardous or explosive dusts.
Contact your local distributor if you require a machine capable of performing these tasks.
The machine must not to be used by persons with reduced physical, sensory or mental capabilities, or lack
of experience or knowledge, unless they have been given supervision or instruction.
You must not allow the supply cord to come into contact with rotating brushes (if fitted).
Only use the socket outlet on the machine for purposes specified in the instructions (where fitted).
This machine is not a toy; children shall not play with this machine.
This machine must not be stored outside, or used in wet environments, or to collect wet materials. The
vacuum cleaner should be stored in a dry place and is for indoor use only.
You must ensure that the filtration system fitted to the machine is suitable for the material being collected.
This product complies with the requirements of IEC 60335-2.69.
This machine is suitable for commercial use, for example in hotels, schools, hospitals,
factories, shops and offices for other than normal housekeeping purposes.
If the vacuum cleaner stops working, remove the plug from the wall before investigating where the fault
lies.
If the vacuum cleaner has a blockage, switch off, remove the plug from the socket outlet, and inspect the
floor tool, wands and hose for debris. If the floor tool, wands and hose are clear, replace the dust bag and
clean the filter.
The vacuum cleaner should be inspected after use for damage.
233816 0512 (A03)