Page 2
The Gige® logo is registered mark of the Automated Imaging Association. All Tattile's systems were created to be alive, smart and open products. Therefore, we give you the chance to update features and capabilities during the whole life cycle of the products.The Download area of our web site has been created to allow our Partners to download new releases of Firmware and Software: http://www.tattile.com.
Index Mechanical Dimensions........................4 Connectors and Indicators.........................5 General Characteristics........................6 CCD General Characteristics......................7 Interface Connection........................11 Example of Connection........................14 Instructions for a right installation of TATTILE control equipment...........16 Warning!............................17 Revisions............................18...
TAG-2 CAMERA General Characteristics Characteristics Electric Characteristics Power Supply +24V Power Consumption Sensor Progressive scan CCD sensor Digital Inputs 2 optoisolated inputs 24Vdc 20mA Digital Outputs 2 PNP optoisolated outputs 24Vdc 500mA Ethernet Network GigaEthernet 10 bit Processor: Microprocessor Altera NIOS FPGA Technology...
TAG-2 CAMERA CCD General Characteristics CCD Specifications kai2001 Parameters Value Interline CCD, Progressive Scan Architecture 1640 (H) x 1214 (V) = approx. 1.99M Total Number of Pixels 1608 (H) x 1208 (V) = approx. 1.94M Number of Effective Pixels 1600 (H) x 1200 (V) =approx. 1.92M...
Page 8
TAG-2 CAMERA CCD Quantum Efficiency Picture 1 – Monochrome Quantum Efficiency Picture 2 – Color Quantum Efficiency...
Page 9
TAG-2 CAMERA CCD Specifications kai0340D Parameters Value 3 Channel, RGB Ttrilinear Architecture 696 (H) x 492 (V) = 342,432 Total Number of Pixels 640 (H) x 480 (V) = 307,200 Number of Active Pixels 7,4 µm (H) x 7,4 µm (V) Pixel Size 5,92 mm (diagonal);...
Page 10
TAG-2 CAMERA CCD Quantum Efficiency Picture 3 – Monochrome Quantum Efficiency Picture 4 – Color Quantum Efficiency...
For connection between TAG-2 CAMERA M0 and PC use a cross-over cable. Note: Connection using Switches/Routers A maximum of 4 TAG-2 CAMERA can be connected to a personal computer, by using a network router or an ethernet switch.
Page 15
For connection between PC and switch/router and between switch/router and TAG-2 Note: CAMERA use ethernet direct cables. The TAG-2 CAMERA can be connected to a network factory, by using a network router or an ethernet switch. For connection between PC and switch/router and between switch/router and Smart Note: Reader M0 use ethernet direct cables.
TATTILE declines all responsibility for anomalous equipment operation, installed with criteria not respecting these instructions. TAG-2 CAMERA cable courses must be kept separate from power cables. • Pay attention to the various connections, especially in respect to the correct •...
TAG-2 CAMERA Warning! The warranty covering TATTILE equipment is invalidated when : 1. The equipment has been opened or tampered with. 2. Faults due to incorrect connection of power or input/output circuits. 3. Faults due to overload or non-compliance with equipment's rated specifications.
TAG-2 CAMERA Revisions The Revision Index is reported below. The various revisions can contain additional information or corrections of printing errors. Rev. Date Page Description Prepared Checked Approved December 03.00.00 First release Nicola G. G.Gualeni Nicola F. 2005...