Advertisement
Rudder & Tiller
Assembled and mounted
3
Rudder assembly
Attach the rudder to the tiller using the supplied bolt, nut, and
washers. The washers sit between the tiller and the rudder, one on
each side.
Daggerboard
Locate the daggerboard and the short line labeled daggerboard
handle. Pass the two ends of the line through the two aft holes in
the top of the daggerboard and tie stopper knots, so that the line
forms a short handle on top of the board.
Place the daggerboard in the boat, close to the mast. Pass the
daggerboard safety line through the third (smaller) hole in the top
of the daggerboard, forward around the mast, and attach the brummel
hooks to the shock chord with stopper knots. Then connect the two
brummel hooks. This line keeps the daggerboard with the boat and
should be secured at all times while sailing, to prevent loss of the
daggerboard.
Handle
Brummel Hooks
Daggerboard
Daggerboard Trunk
w w w . t e a m v a n g u a r d . c o m
Advertisement
