Page 1
Homeowner’s Installation Instructions & Operating Manual Model: DY-BT35 DY-BT44 DY-BT55 DY-BT63 DY-BT79 READ AND SAVE THESE INSTRUCTIONS READ CAREFULLY BEFORE ATTEMPTING TO ASSEMBLE, INSTALL, OPERATE OR MAINTAIN THE PRODUCT DESCRIBED. PROTECT YOURSELF AND OTHERS BY OBSERVING ALL SAFETY INFORMATION. FAILURE TO COMPLY WITH INSTRUCTIONS COULD RESULT IN PERSONAL INJURY AND/OR PROPERTY DAMAGE.
IMPORTANT INSTRUCTIONS When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electrical shock,and injury to persons including the following: 1. Read all instructions before using this appliance. 2. This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. Keep combustible materials, such as furniture, pillows, bedding, papers, clothes and curtains at least 3 feet (0.9m) from the front of the heater and keep them away the sides and rear.
INSTALLATION INSTRUCTION TOOL REQUIRED Magnetic Phillips Screw Driver UNPACKING THE ELECTRIC FIREPLACE WARNING! Do NOT use this Electric Fireplace if any part has been under water. Immediately call a qualified service technician to inspect and to replace any part of the electrical system if necessary.
Page 4
MODEL DY-BT35 DY-BT44 1055 1095 1124 DY-BT55 1355 1395 1424 DY-BT63 1555 1595 1624 DY-BT79 1955 1995 2024 LOCATING YOUR ELECTRIC FIREPLACE Your new electric fireplace may be installed virtually anywhere in your home. However, when choosing a location ensure that the general instructions are followed.
Page 5
ELECTRICAL SPECIFICATIONS Voltage ………………………………..120V AC, 60 Hz Total Amps ……………………………..… 10.8AMP Total Watts …………………………….……1300Watts ELECTRICAL CONNECTION WARNING! Electrical wiring must comply with local building codes and other applicable regulations to reduce the risk of fire, electrical shock and injury. Note: All wiring must be completed prior to finishing the unit.
MAINTENANCE WARNING: ALWAYS DISCONNECT POWER BEFORE SERVICING. DO NOT IMMERSE HEATER IN WATER! Always turn OFF the heater and disconnect power before cleaning your heater. Light accumulated dust may be removed from the heater with a soft cloth or vacuum cleaner. Wipe the exterior surfaces of the heater occasionally with a slightly damp cloth (not dripping wet) using a solution of mild detergent and water.
Page 7
Flame button The fire has four flame effects and a standby, by pressing the flame effect button the unit will cycle through each condition. Heater button Press once turns 650W power on. (Pilot lights illuminated ●○) Press again turns 1300W power on (Pilot lights illuminated ●●) Press third time turns heater off.
Proof of purchase will be required so the original invoice should be retained. Dynasty Fireplaces #10-3071 No. 5 Road, Richmond, BC V6X 2T4 Canada Telephone: (604) 821-1009 Toll free: 1-877-521-1009...
Need help?
Do you have a question about the DY-BT35 and is the answer not in the manual?
Questions and answers