Advertisement

CSADL6000I/E
CSADL6000IE/E
INSTALLATION, OPERATION,
and MAINTENANCE INSTRUCTIONS

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CSADL6000I/E and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Dyna CSADL6000I/E

  • Page 1 CSADL6000I/E CSADL6000IE/E INSTALLATION, OPERATION, and MAINTENANCE INSTRUCTIONS...
  • Page 2: Table Of Contents

    COPY YOUR MODEL AND SERIAL USING THIS MANUAL NUMBER HERE No other DYNA generator has the same serial number Congratulations on your choice of a DYNA generator as yours. It is important that you record the number and set. You have selected a high-quality, precision- other vital information here.
  • Page 3: Guide To Product Safety

    GUIDE TO PRODUCT SAFETY 3. DEADLY EXHAUST GAS - Exhaust fumes from any gasoline engine contain carbon monoxide, an invisible, This engine generator set has been designed and odorless and deadly gas that must be mixed with fresh air. manufactured to allow safe, reliable performance. Poor maintenance, improper or careless use can result in potential a.
  • Page 4: Intended Uses

    INTENDED USES Check the appliance or tool nameplates for the current and voltage to insure compatibility. Remember that power taken These engine generator sets have been designed primarily from receptacle C reduces the power available at both A and for portable use. Both 120 and 240 volt AC receptacles are B.
  • Page 5: Unit Preparation

    UNPACKING BATTERY INSTALLATION CAUTION: EQUIPMENT DAMAGE If you intend to use the power plant’s electric start system, you will need to purchase a battery to operate it. Units THIS UNIT HAS BEEN SHIPPED WITHOUT OIL. Failure equipped with a recoil or rope start will operate satisfactorily to maintain the engine oil at the proper level will result in without a battery.
  • Page 6: Starting

    STARTING HINTS Optional Dolly Kit 1. Cold weather An optional dolly kit is available for this engine generator set. The dolly kit comes with instructions and parts list. After a. Use the proper oil for the temperature expected. b. Use fresh winter grade fuel. Winter grade installing the dolly kit, file the instructions and parts list in the back of this manual for future reference.
  • Page 7: Connecting The Loads

    Although individual units and models may vary slightly, the Proper utilization of the receptacles located on the control panel is necessary to prevent damage to either the normal voltage and frequency of the engine-generators described in this book are approximately as follows, under receptacles or the generator.
  • Page 8: Engine Care

    CAUTION: EQUIPMENT OVERLOAD c. Wash foam pre-cleaner in liquid detergent and water Keep the generator load within the generator and d. Wrap foam pre-cleaner in cloth and squeeze dry. receptacle nameplate rating. Overloading may cause e. Saturate foam pre-cleaner in engine oil. Squeeze damage to the generator and/or the loads .
  • Page 9 TROUBLESHOOTING HINTS Voltage too high *Engine speed is too high. —————————————————————————— PROBLEM (SYMPTOMS) POSSIBLE CAUSES Generator *Overloaded. —————————————————————————— overheating *Insufficient ventilation. Won’t Start *Low oil level. —————————————————————————— *Fouled spark plug. No output voltage *Short in load (disconnect). *Out of fuel. *Broken or loose wire.
  • Page 10: Complete Unit Parts List

    COMPLETE UNIT ASSEMBLY REF# Part Number Description 467-000 Cap Screw 5/16-18 X .75 480-000 Lockwasher 5/16 64062-000 Shock Mounts 16249-000 Locknut 5/16-18 16250-000 Flange Nut 3/8-16 464-000 Cap Screw 3/8-16 X.75 16335-007 Generator Support 15676-005 Battery Tray (1) 15767-005 Negative Battery Cable (1) 15767-016 Positive Battery Cable (1) 15807-000...
  • Page 11: Receptacle Panel Parts List

    REF# Part Number Description 15482-000 Gas Cap 16346-006 Complete Generator Assembly 15632-007 Engine B/S Intek (1) 210317-0191-B1 15632-008 Engine B/S Intek (2) 210312-0190-B1 468-000 Cap Screw 5/16-18 X 1.5 480-000 Lockwarsher 5/16 466-000 Cap Screw 1/4-20 X .75 512-000 1/4 Flat Washer 16133-000 Leather Washer 81018-008...
  • Page 12: Wiring Diagram

    24 MONTH Limited Warranty WINCO warrants to the original purchaser that the alternator is free from defects in workmanship and material for a period of two years*, provided it is installed, operated and maintained in accordance with WINCO written instructions. *NOTE: Units used for rental, demonstrations, commercial or prime power (off grid) applications such as construction or utility, are warranted for 90 days.

This manual is also suitable for:

Csadl6000ie/e

Table of Contents