Quick Setup Guide - Sanyo VHR-790 Instruction Manual

iiiii
1
START
This page is designed to get you started if you are in a hurry, but please read the
full instructions manual to get the best from your VCR.
UNPACK UNIT
@
•1
Power cord Aerial output cable
~~
El
Remote control unit 2 "AA (IEC R6)" size,
batteries
<___ :.
CONNECT TO TV
AS INDICATED
TV
Aerial
To a wall socket +i
Power c
IAL IN
IAL OUT
Aerial output cable
Y
SETTING THE TV TO THE VIDEO CHANNEL )
1
6
(!)1
Turn off the VCR using the
(5/1
button.
—
2
El
VCR
Turn on your TV and set your TV to "VCR", "O' or the
position designated for VCR use (always a position
where no TV programme is received).
00
3
PRESET
Press the PRESET button on the VCR remote
VCR display
control for more than 3 seconds.
The VCR
display shows "28 RF.
-
L )
4
for Australia
Lp--]
for New Zealand
5
PRESET
When completed, press the PRESET button.
o
The VCR is turned off.
J
Set the UHF channel using the CH+ (for Australia) or
CH- (for New Zealand) button on the VCR remote
control, so that the
test pattern (2 vertical bars) appears.
RF converter output (Video channel)
(for Australia)
Area I Factorv setting I Range
Australia
I
28
I
28-69
New Zealand 28 22-69
Adjust the tuning on the TV, if necessary, so that the test
pattern is clear.
(for New Zealand)
00