First Time Use - Swann SR11010 Installation And User Manual

Installation Notes
4. Ensure the supply voltage of scoket is same as rating label.
5. The plug must be properly inserted to the wall socket.
6. The mains supply socked must be earthed - preferably with a switch. If it is not
earthed, do NOT install this appliance there. Do not use an extension cord
7. The product is equipped with adjustable feet. Once the product is in place, adjust
these to ensure the fridge is level and doesn't rock.
DO NOT SITE THE PRODUCT WHERE THE AMBIENT TEMPERATURE IS LIKELY TO
DROP BELOW 5 DEGREES CENTIGRADE - EG: GARAGE OR SHED

First Time Use

1. It is important that upon receipt you stand your appliance upright for at least 4
hours before switching on to allow the system to settle
2. When using the refrigerator for the first time, set the thermostat inside the
refrigerator to 5 without any food inside. When the refrigerator starts, you will hear
the quiet hum of the compressor. You may also hear the circulation of liquids and
gases in the refrigeration system. This is normal on first start up, Generally it will
take 2-3 hours for the appliance to reach temperature. Once temperature has been
reached then put the food inside.
3. The temperature of the refrigerator can be adjusted by rotating the disc of the
thermostat. The higher the value on the setting of the thermostat, the maximum
value of refrigeration (coldest being 7 ). Typically a medium setting of 4-5 is best for
most circumstances.
4. Do not put too much food in the refrigerator. Avoid opening the doors too fre-
quently as this will waste energy and can cause excessive frost build-up.
6
SR11010.indd 6 21/07/2014 10:42