Kia Optima Manual page 124

Retain the original transmitter of the
RF device you are programming for
use in other vehicles as well as for
®
future HomeLink programming. It is
also suggested that upon the sale of
the vehicle, the programmed
®
HomeLink buttons be erased for
security purposes.
®
Programming HomeLink
✽ ✽ NOTICE
• When programming a garage
door opener, it is advised to park
the vehicle outside of the garage.
• It is recommended that a new bat-
tery be placed in the hand-held
transmitter of the device being pro-
grammed to HomeLink ®
er training and accurate transaxle
of the radio-frequency signal.
• Some vehicles may require the
ignition switch to be turned to the
second (or "accessories") position
for programming and/or opera-
®
tion of HomeLink .
• In the event that there are still pro-
gramming difficulties or questions
after following the programming
steps listed below,
®
HomeLink at: www.homelink.com
or 1-800-355-3515.
Features of your vehicle
Standard programming
To train most devices, follow these
instructions:
1. For first-time programming, press
and hold the two outside buttons,
®
HomeLink
Channel 3 Buttons, until the indi-
cator light begins to flash (after 20
seconds). Release both buttons.
for quick-
Do not hold the buttons for longer
than 30 seconds.
2. Position the end of your hand-held
transmitter 1-3 inches (2-8 cm)
away from the HomeLink
while keeping the indicator light in
view.
3. Simultaneously press and hold
both the HomeLink
held transmitter button. DO NOT
contact
release the buttons until step 4
has been completed.
4. While continuing to hold the but-
tons the red Indicator Status LED
will flash slowly and then rapidly
after HomeLink
trains to the frequency signal from
the hand-held transmitter. Release
both buttons.
Channel 1 and
®
buttons
®
and hand-
®
successfully
4 51