Wiring Examples; Standard Setup Consisting Of Guitar, Footswitch And External Effects Device; Expanded Setup With Midi Footcontroller, Playback Source And Mixing Console - Behringer BLUE DEVIL GX112 User Manual

+
Please note that when using the serial effects path, the external effect should not be set to
100% wet (100% effect signal); otherwise, there will be no direct signal portion fed back to the
BLUE DEVIL.
30
Connect the enclosed footswitch FS112 via the stereo plug to the FOOTSWITCH jack. The footswitch
allows you to change channels or disable the effects module.

2. WIRING EXAMPLES

2.1 Standard setup consisting of guitar, footswitch and external effects device

To use your BLUE DEVIL for rehearsals or on stage, please wire up the unit as shown in fig. 2.1. Of course,
you can also use a wah-wah or other pedal effect instead of the external 19" effects unit, or simply work with
the internal effects without having to use the insert path. Connecting the headphones will mute the built-in
speaker.
When you wish to use a guitar tuner, please connect it to the INSERT SEND of your BLUE DEVIL. If there is
no further effects device connected, you can leave the INSERT RETURN as it is. However, to use an external
effects device, place the tuner before the effects in the signal chain, so that its signal won't be processed by
the effects device.

2.2 Expanded setup with MIDI footcontroller, playback source and mixing console

To use your BLUE DEVIL for advanced applications, please consider the following suggestions. Of course,
the expanded configuration suggested in fig. 2.2 builds on the standard setup described in chapter 2.1.
Use the MIDI foot controller to change presets and/or channels, set volume and wah, etc. The LINE OUT
signal can be fed into a P.A. or recording console, and the AUX INPUT can be used to play back e.g.
cassette recorder signals through the GX112.
BLUE DEVIL GX112
Fig. 2.1: Standard setup
2. WIRING EXAMPLES 11