Table of Contents
Advertisement
1.
Lazy Mode: This device support the Lazy Mode to automatically learn the MAC
address of WDS peers, you don't have to input other peer AP's MAC address.
However, not all the APs can be set to enable the Lazy mode simultaneously; at
least there must be one AP with all the WDS peers' MAC address filled.
2.
Green AP: Enable the Green AP function to reduce the power consumption
when there is no wireless traffics.
3.
Wireless Schedule: The wireless radio can be turn off according to the schedule
rule you specified. By default, the wireless radio is always turned on when the
wireless module is enabled.
4.
Network ID (SSID): Network ID is used for identifying the Wireless LAN (WLAN).
Client stations can roam freely over this device and other Access Points that
have the same Network ID. (The factory default setting is "default")
5.
SSID Broadcast: The device will broadcast beacons that have some information,
including SSID so that wireless clients can know how many AP devices by
scanning the network. Therefore, if this setting is configured as "Disable", the
wireless clients can not find the device from beacons.
6.
VLAN ID: Supports mapping of SSIDs to VLANs to separate workgroups across
wireless and wired domains.
7.
Max Supported Stations: Support Max Stations to associated related SSID.
8.
Channel: The radio channel number. The permissible channels depend on the
Regulatory Domain. The factory default setting is auto channel selection.
Wireless Mode: RF1 Module can choose "N only", "G/N mixed" or "B/G/N
9.
mixed" and the factory default setting is "B/G/N mixed".RF2 Module can choose
"A only", "A/N mixed", "N only", "G/N mixed" or "B/G/N mixed" and the factory
23
Hide quick links:
Advertisement
Table of Contents
