Advertisement
MOUNTING
Surface Mounting (See Figure 1.)
1. Position the light unit with the flange attached on the mounting surface and mark
the position of the two screws and a center wire passage hole.
2. Drill two holes for the screws and a 0.5" center wire passage hole.
3. Place the light unit on the mounting surface and secure it with the included
hardware.
Headlight or Tail Light Mounting (See Figure 2.)
1. Refer to your vehicle's manual for instructions on how to remove the headlight or
taillight assembly.
2. Select the mounting location and choose a surface in the bottom or rear of the
light assembly as close to the focal point as possible. Be sure that it doesn't
interfere with the operation of the light.
3. Use a saw to cut a 1" hole in the chosen location. Insert the light unit into the hole
and mark the location of the two screw sockets. Remove the light and drill the two
holes.
4. Place the gasket on the light and insert it in the hole. Use metal screws to secure
it to the light assembly.
5. Reinstall the headlight or taillight assembly and route the wires to their
appropriate control switches.
SPECIFICATIONS
Dimensions: 0.99" H, 1" D
Input Voltage: 10-30VDC Input Current: 1.4A (MAX)
Figure 1.
Figure 2.
Optional Brackets
Advertisement
