Kenwood TK-3201 Service Manual Supplement page 14

TK-3201
2. Repair Jig (Chassis)
Use jig (part No.: A10-4086-03) for repairing the transceiver.
Place the TX-RX unit on the jig and fit it with screws.
The jig facilitates the voltage check and protects the final
amplifier FET when the voltage on the flow side of the TX-RX
unit is checked during repairs.
3. Battery Jig (W05-1011-00)
Connect the power cable properly between the battery jig
installed in the transceiver and the power supply, and be sure
output voltage and the power supply polarity prior to switching
the power supply ON, otherwise over voltage and reverse
connection may damage the transceiver, or the power supply
or both.
Note: When using the battery jig, you must measure the
voltage at the terminals of the battery jig. Otherwise, a slight
voltage drop may occur within the power cable, between the
power supply and the battery jig, especially while the
transceiver transmits.
SCHEMATIC DIAGRAM
S
–
+
14
ADJUSTMENT
+ Terminal (Red)
– Terminal (Black)
+ Terminal – Terminal
(Red) (Black)
Power cable
Power
supply