Advertisement
1.
FORK POSITION
The front wheel has been removed and the fork may have been reversed for shipping. In the proper position, the fork
dropout will face forward. If you find the fork is not in this position, spin the fork 180 degrees. Spin so the brake cable
does not wrap around the head tube. In the correct position the fork dropout will be facing forward (1-A & 1-B)
Rim brake
1-A
2.
INSTALL HANDLEBAR Required tool- 5mm or 6mm hex wench
With the fork in the correct forward position, remove the bolts from the handlebar clamp (2-A). With the handlebar
clamp plate removed, center the handlebar on the handlebar clamp portion of the stem and place the handlebar clamp
plate over it. Ensure that all cables are seated into cable stops properly and are routed in smooth rounded paths, not
pinched or bent (2-B). Carefully thread bolts in and tighten until snug (2-C).
Stem
Handlebar
2-A
clamp
QUESTIONS: Should you have any questions during the final assembly of your new bicycle, please call our product
11/12/13
specialists at 800-226-7552 any day between 8:00 a.m. and 10:00 p.m. Eastern.
Head tube
Fork dropout in
proper forward
facing position
2-B
Disc brake
1-B
2-C
pg. 2
Advertisement
