Table of Contents
Advertisement
Quick Links
SeriesTWO
RGB Fluorescent Fixtures
Installation and
Instruction Manual
Brightline LP 580 Mayer Street #7, Bridgeville PA 15017
Phone 1-412-206-0106 Fax 1-412-206-0146 www.brightlines.com
Advertisement
Table of Contents
Related Manuals for Brightline TWO series
Summary of Contents for Brightline TWO series
- Page 1 SeriesTWO RGB Fluorescent Fixtures Installation and Instruction Manual Brightline LP 580 Mayer Street #7, Bridgeville PA 15017 Phone 1-412-206-0106 Fax 1-412-206-0146 www.brightlines.com...
- Page 2 The Brightline Mini-Cyc Series models are controllable, fluorescent color changing fixtures designed to be used for perimeter lighting, light walls, cove lighting or behind semitransparent materials. These fixtures combine high frequency electronics with state of the art optical system to produce a soft, full color spectrum, flicker free light source.
- Page 3 Installation 1. Prepare the AC power and DMX control wiring to the Start Master fixture. 2. Install the Start Master fixture as described in the Installing Start Master section. 3. You can install a Remote fixture immediately after the Start Master fixture as described in the Installing Remote Fixture section.
- Page 4 Installing Remote Fixture 1. If mounting the Remote fixture through the holes of the fixture housing, remove the reflective cover by loosening the # 6-32 Phillips head screws. 2. Insert the AC Power input plug of the Remote fixture into the AC Power output receptacle of the previous Master fixture.
-
Page 5: Setting The Dmx Address
Setting the DMX Address DMX Fixtures receive their intensity information from a DMX signal, provided by a control console or other DMX device. The fixture must be on when performing this procedure. 1. Using a paperclip or similar device, the DMX address can be set by pressing the Up or Down recessed adjustment buttons on the left side of the Channel Indicator. -
Page 6: Specifications
3. Insert the pins of the lamp into the appropriate sockets of the fixture. 4. Holding the lamp at each end, rotate approximately 90° until the lamp is locked into position in both sockets. 5. Repeat steps #3 and #4 for the remaining lamps. Note: New fluorescent lamps must be burned in at full intensity for 100 hours to obtain the full 20,000 hour life time. - Page 7 Finish: Low glare, polyester powder coat RAL9010 standard; custom finish colors available. Power and Control Wiring: Modular input/ and or output connectors for DALI or DMX signal and the AC power supply Optional Accessories: Lens: Removable acrylic prismatic lens. Mounting brackets for lens to be attached to fixture.
Need help?
Do you have a question about the TWO series and is the answer not in the manual?
Questions and answers