Related Manuals for Brightline 1.1N
Summary of Contents for Brightline 1.1N
-
Page 1: Operating Instructions
1.1N Operating Instructions 580 Mayer Street, Building #7, Bridgeville, PA 15017 • phone 412.206.0106 • fax 412.206.0146 www.brightlines.com © 2006 Brightline, L.P... -
Page 2: Owner's Record
Model No.________________________ Serial No.________________________ Date of Purchase__________________ Product Description • The Brightline 1.1N is a 1-lamp, 55-watt, energy-efficient light fixture. This fixture combines high-frequency electronics with a state-of-the-art optical system to produce a soft, full-spectrum, flicker-free light source. -
Page 3: Installing The Yoke
Installing the Yoke #10 Screw Palm Handle #10 Washer 1. Position yoke over mounting holes in fixture (Fig. 1). Figure 1 2. Thread #10-32 screw and flat washer into place as shown (Fig. 1). Figure 2 3. Repeat Step #2 for remaining screw and washer (Fig. 2). Adjusting the Yoke Palm Handles 1. -
Page 4: Installing Lamps
Installing Lamps 1. Place lamp into clip as shown in Figure 4. Lamp Clip Figure 4 2. Gently slide lamp into socket (Fig. 5). Note: The socket’s locking tabs will snap into indents on the base of the lamp. Figure 5 Installing Adapters (C-Clamp/Spud) 1. -
Page 5: Installing Accessories
Installing Accessories 1. Swing latch open (Fig. 8). Figure 8 Detail A 2. Insert accessory into the track (see Detail A) and slide it forward until it stops (Fig. 9). Figure 9 3. Swing latch closed and fasten in place (Fig. 10). Figure 10... -
Page 6: Replacing Fuse
Replacing Fuse 1. Pull fuse holder out of power inlet module. 2. Remove fuse holder and check for wear (Fig. 11). If fuse is blown, replace with a new fuse or the on-board spare (Fig. 12). 3. Return fuse holder to a closed position. Active Fuse On-board Spare Figure 12... -
Page 7: Troubleshooting Guide
Troubleshooting Guide Problem Possible Cause Solution Lights flicker or drop out Defective or damaged Replace with new lamps or exchange at low end. lamps. lamps from a known good fixture. Lights are flashing or Wrong voltage for ballast Verify that the ballast's voltage is strobing. -
Page 8: Specifications
Specifications Mounting: 10-gauge (.125) aluminum yoke, Housing: 14-gauge (.060) formed, aluminum sheet-metal construction. formed construction. 2” O.D. pipe clamp or TVMP adapter provided. See finish note. Power Entry Module: 5-amp fuse Reflector: 24-gauge (.020) formed aluminum (with onboard spare) and IEC connector sheet-metal construction. - Page 9 Wiring Diagram - NonDim...
-
Page 10: Warranty
WARRANTY Brightline guarantees all its products to be free from defects in materials and workmanship for a period of one (1) year from the date of shipment. PROCEDURES If any product is found to be unsatisfactory under this warranty, the buyer must notify immediately. - Page 11 Notes...
Need help?
Do you have a question about the 1.1N and is the answer not in the manual?
Questions and answers