Advertisement
LINE OUT
AUX
GUITAR
BALLS
BIGGER
INPUT
INPUT
1
2
3
4
1.)
Line Output -
this is a 3 cond. XLR output jack for plugging into Lo-Z microphone inputs as found on PA or
recording mixers. It is intended in place of external mics or used as a built in direct box.
2.)
CD/Tape Input -
this 1/4" 3 conductor jack will allow you to plug in a CD player, tape or any other source to practice
along with. It sums the left and right signals into a mono signal. To control the volume of the source, adjust the output
volume of the device.
3.)
Guitar Input Jack -
will accept other instruments as well.
4.)
B.A.L.L.S. (Ballistic Audio Loudness Level Saturation)- adjust this clockwise to increase the amount of distortion
you Add lower ranges of the control, you get a less distorted sound, a "bluesy"tone .As you increase the gain, you
add Tremendous amounts of distortion to the signal for a harder edged "crunch"tone.
5.)
Bigger B.A.L.L.S.-
6.)
Low -
this control is the bass control for the lead channel. It is passive and set to shelve frequencies at 100 Hz.
Turning it fully clockwise, the signal is unaltered. Turning it counterclockwise, the low will be rolled off -12db.
7.)
Mid -
this control is the midrange control for the instrument channel and is passive and set to shelve frequencies at
800Hz.Turning it fully clockwise, the signal is unaltered. Turning it counterclockwise, the low will be rolled off -12db.
8.)
Preamp Select Switch-
GRIND.
9.)
High -
this is the high frequency tone control for the microphone channel. It is passive and set to shelve frequencies
at 3KHz. Turning it fully clockwise, the signal is unaltered Turning it counterclockwise, the highs will be rolled off -
12db.
10.) Lead Channel On LED -
11.) Volume -
this is a volume control for the Lead Channel ONLY.
12.) Channel Select Switch -
13.) Bass -
this control is the bass control. It is passive and set to shelve frequencies at 100Hz. Turning it fully clockwise,
the signal is unaltered Turning it counterclockwise, the low will be rolled off -12db.
14.) Middle -
this control is the midrange control for the instrument channel, and is passive and set to shelve frequencies
at 1KHz. Turning it fully clockwise, the signal is unaltered. Turning it counterclockwise, the low will be rolled off -
12db.
15.) Preamp Switch -
+6 db.
16.) Treble -
this is the high frequency tone control. It is passive and set to shelve frequencies at 3KHz on the instrument
channel. Turning it fully clockwise, the signal is unaltered. Turning it counterclockwise, the highs will be rolled off -
12db.
17.) Rhythm Channel On LED -
18.) Volume -
this is a volume control for the Rhythm Channel ONLY.
19.) Effects On/Off -
this switch engages the digital effects section.
20.) Effects Level -
this control adds the digital effects section and mixes it into the main signal buss. Several different
effects are available.
21.) Program Select -
Flange/Reverb and Tremolo.
22.) Jewel Light -
this jewel light lets you know that the amplifier is on.
23.) Power Switch -
this switch turns on and off the AC power to the amp.
Back Panel - (not pictured)
Speaker Out -
these are 2 conductor 1/4" speaker output jacks. Rating is 4 ohms total. If using both jacks, a load
lower than 8 ohms per jack is not recommended. If using one jack, a load lower than 4 ohms is not recommended.
Line Output -
this is a 2 conductor 1/4" line output jack. This will allow an external amplifier or mixing board to be
supplied with the signal from this amp.
Effects Loop I/O -
Footswitch Jack -
on/off the effects section.
LEAD CHANNEL
LOW
MID
HIGH
PREAMP
BALLS
ON
PUNCH
OFF
GRIND
5
6
7
8
9
this is a 1/4" 2 conductor input jack for plugging in your instrument. It is intended for guitars but
this switch will add more distortion to the lead channel.
this switch selects which preamp style you are using. It will switch between the PUNCH and
when this LED light is on, it indicates that the Lead Channel is on.
this switch selects between the Lead or Rhythm Channel.
when engaged, this switch will boost the treble sound of the Rhythm channel. It boosts 3 KHz by
when this LED light is on, it indicates that the Rhythm Channel is on.
this switch will select any of eight different effects. 2- Reverbs, 2- Echos, Chorus, Chorus/Reverb,
This is an effects Insert jack. Tip send (preamp out) and ring return (power amp in).
this is a 3 conductor 1/4" jack. This is for hooking up a footswitch to switch channels and to turn
RHYTHM CHANNEL
VOLUME
BASS
MIDDLE
CHANNEL
PREAMP
SELECT
LEAD
RHYTHM
10 11 12 13
14 15
DIGITAL EFFECTS
TREBLE
VOLUME
LEVEL
EFFECTS
LEAN
ON
FAT
OFF
16
17
18
19
20
PROGRAM
Quad 100 HD
5
1. HALL REVERB
4
6
2. SPRING REVERB
3. SLAP BACK
7
3
4. DELAY
5. CHORUS
6. CHORUS/REVERB
2
8
POWER
1
7. FLANGE/REVERB
8. TREMOLO
21
22
23
Advertisement
