Eartec SC1000 Quick Manual

Safety & General Information
Important Information for Safe and Efficient Operation. Please read this information before
using your radio.
Safety and General
1. Do not transmit more than 50% of time. It is important as the radio generates measurable RF energy exposure only when transmitting.
2. Changes or modifications not expressly approved by the manufacturer could void the user's authority to operate the equipment.
3. Radio frequency signals transmitted may cause interference to hearing aids.
4. Turn off the radio when near medical equipment.
5. This product should not be used by people with pacemakers.
6. Do not use the radio when driving a vehicle or operating machinery.
7. Do not use the radio when on board aircraft.
8. Do not hold the antenna when transmitting.
9. Do not use the radio when the antenna has damaged.
10. Turn off the radio and remove the batteries if you are not going to use it for a long time.
Two-way Radio Operation
The device was tested for typical body-worn operations using the supplied belt-clip. To maintain compliance with FCC RF exposure require-
ments, body-worn operations are restricted to the supplied belt-clip. For hand-held operation, the radio should be held at least 1 inch (2.5cm)
from the user's face. The use of accessories that do not satisfy these requirements may not comply with FCC RF exposure requirements and
should be avoided. For more information about RF exposure, please visit the FCC web site at www.fcc.gov.
OPERATIONAL CAUTIONS
1. Never dispose of batteries in a fire. There is a serious risk of explosion and /or the release of highly toxic chemicals.
2. Do not expose your product to direct sunlight, extreme cold or place it near heating appliances.
3. Do not submerge any part of your product in water and do not use it in damp, humid or wet conditions.
4. Do not expose your product to fire, explosive or other hazardous conditions. For example, at petrol stations or areas where explosive prod-
ucts are used.
FCC ID:
B4HSC1000
FCC Statements
This device complies with Part 15 of the FCC Rules. Operation is subject to the following conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any interference received, including interference that may
cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accor-
dance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Warranty
Eartec communication systems are warranted from malfunction due to manufacturing defects by the original purchaser for the
following periods after date of purchase:
Transceivers Headsets
Digicom 1 year Heavy Duty
MC-1000 1 year Midweight
TD900 6 months Lightweight
Simultalk 24G 6 months Rechargeable batteries
What is Covered
If you require warranty service for your product within the warranty period ship your product pre-paid only to Eartec.
The end user is responsible for the initial shipping charges to our facility. Eartec will pay the return ground shipping charges if the product is
covered under the warranty.
This warranty covers defects in materials and workmanship in all Eartec products excluding:
(a) Damage from misuse, abuse, or general wear and tear.
(b) Repairs or product modifications by anyone not authorized by Eartec Co.
General Service / Returns
All repair work due to general wear and tear will be performed for the cost of replacement parts, radio re-
tuning and return shipping from the Eartec factory.
Service, Eartec Co.
145 Dean Knauss Drive COD or Collect deliveries will not be accepted.
Narragansett, RI 02882
1-800-399-5994 or (401) 782-4966
A letter explaining any problems and work to be performed must accompany each repair shipment with: Name, Busi-
ness, Complete Address, Telephone Number, Email Address
Eartec products may be returned for credit or refund only if received in the original packing and in "As New" condi-
tion within 30 days of date of purchase.
1 year
6 months
30 days
60 days
11/2010
Scrambler UHF
Model SC 1000
Professional
Two-Way Radio
Encrypted High Band Transceiver
www.eartec.com