Assembly Hints - Nokia Asha 200 Service Manual

11. ASSEMBLY HINTS

1) Connect the DISPLAY connector to the ENGINE
BOARD. Use the sharp end of the SS-93 to bend the
DISPLAY flex while carefully pushing the DISPLAY to
the direction shown. Be careful not to bend too close
to the connector.
3) Start to assemble the ENGINE BOARD including the
DISPLAY and the UI FRAME to the B-COVER top side
first. Use the USB connector and the shown pin to get
the right alignment.
5) Tighten the four Torx+ size 6 screws to the torque
of 17 Ncm.
19
2) Carefully push down the DISPLAY flex.
4) Push down to attach the ENGINE BOARD including
the DISPLAY and the UI FRAME to the B-COVER.
6) Before assembling the B-COVER to the A-COVER,
open the SD DOOR and the SIM2 DOOR.
Conf idential | Copyright © 2011 Nokia | A ll rights reserved
Nokia Asha 200 (RM-761)
Nokia Asha 201 (RM-799/RM-800)
Service Manual Level 1&2
Version 1.0