Dear customer! Thank you for buying a Scarlett television. Before operating the unit, please read this manual thoroughly, and retain it for future reference. TABLE OF CONTENTS Important safeguards......................3 Preparation........................4 Remote control.........................6 Front panel controls......................7 Menu Setting the language.......................8 Setting the programs......................8 Setting the programs manually..................9...
IMPORTANT SAFEGUARDS · Before the first connecting of the appliance check that voltage indicated on the rating label corresponds to the mains voltage in your home. · Do not use the color television for any other purposes than those described in this instruction manual.
PREPARATION CONNECTING TO AN AERIAL OR CABLE TELEVISION NETWORK To view television channels correctly, a signal must be received by the set from one of the following sources: - an outdoor aerial; - a cable television network. 1. Connect the aerial or network input cable to the coaxial socket on the rear of the television.
REMOTE CONTROL : Turns the TV on or sets the TV to the stand-by mode. : Sets the sleep time. The time counts up with each press as follows: 00:00 0:20 0:40 2:00 1:40 1:20 1:00 After the set amount of time has elapsed, the TV automatically enters the stand-by mode. To cancel the sleep timer press button until 00:00 appears.
Sub-page key allows you to access any of these pages directly by keying in its own number. Press the Sub-page key and enter four digits for the page you want, e.g. page 2 would be 0002. When the sub-page has been found it will be displayed.
SETTING THE LANGUAGE The view of some illustrations and diagrams can differ from original, which you will see on the TV display. We have simplified them for easy reference. The on-screen menu can display any four languages, English, French, German and Russian. 1.
· Automatic tuning may set the same TV station at the upper end of Band I and the lower end of Band III, or at the upper end of Band III and the lower end of UHF. In this case, skip the setting on the band that has poor reception.
TO FINE TUNE You can perform fine tuning of the picture. 1. In the Install (after step 3), press + or - buttons to select Fine Tune . 2. Press + or - buttons until the picture becomes clearer. 3. Press - button to select Store in the Install menu, then press button.
5. Press MENU button three to exit the menu screen. TIMER MENU 1. Press MENU button, then press + or - buttons to select Timer . 2. Press button, then press + or - buttons to select the item. Time: enter the correct time in hours (00 to 23) and minutes (00 to 59) using the number buttons 0,1, ..., 9.
ADJUSTING THE PICTURE The setting you adjust in this menu is memorized to Favourite in the picture mode. 1. Press MENU button, then press + or - buttons to select Picture . 2. Press button, then press + or - buttons to select the item you want to adjust. Brightness: adjusts the brightness.
5. If you wish to display the actual broadcast at the same time as the Teletext page, press the button. 6. To return to your TV picture press button. 7. When you have displayed a Teletext page, you can select various options to suit your requirements: To display ...
Crackling of the housing TV can occur because of its Crackling of the housing TV expansion or narrowing at change of environmental temperature. It is not connected to defect of the TV. Instability of color regarding the If the display becomes bright, it can depend on character display of the transmitted picture.
Need help?
Do you have a question about the SC-TV1404 and is the answer not in the manual?
Questions and answers