KX-T2378JXW CONTENTS Page Page 1 LOCATION OF CONTROLS 9.3. Ringer Circuit 2 DISPLAY 9.4. Tone Detect 3 CONNECTION 9.5. In Use Detector Circuit 3.1. Connecting the Handset 9.6. Hold Circuit 3.2. Connecting the Telephone Line Cord 9.7. Speakerphone Circuit 3.3. Connecting a Communication Device...
3 CONNECTION 3.1. Connecting the Handset Connect the handset as shown below. • • Use only a Panasonic Handset for the KX-T2378JXW. 3.2. Connecting the Telephone Line Cord Connect the telephone line cord(s) to the unit as follows. To connect a two-line telephone jack...
KX-T2378JXW If you use the unit only as a single-line telephone 3.3. Connecting a Communication Device After connecting the telephone line cord to a two-line telephone jack, you can connect a communication device (computer, modem, fax, answering machine, etc.) through this unit using the LINE2/DATA jack.
KX-T2378JXW 4 SETTINGS 4.1. Selecting the Dialing Mode You can select the dialing mode by programming. If you have touch tone service, set to "Tone". If rotary or pulse service is used, set to "Pulse". Your phone comes from the factory set to "Tone".
KX-T2378JXW 4.3. Setting the LCD Contrast You can select the LCD contrast level from 1 to 4 by programming. Your phone comes from the factory set to 3. Make sure that a call is not put on hold. 4.4. Selecting the Ringer Volume...
KX-T2378JXW 5 SPECIAL FEATURES 5.1. FLASH Button 5.2. Selecting the Flash Time The flash time depends on your telephone exchange or host PBX. You can select the following flash times: "80, 90, 100, 110, 200, 250, 300, 400, 600, 700 ms (milliseconds)". Your phone comes from the factory set to "600 ms".
KX-T2378JXW 5.3. Setting the Pin Code A 4-digit PIN Code (Personal Identification Number) prevents unauthorized persons from using your unit. The PIN Code is required for the dial lock and call restriction to be set or canceled. The factory preset PIN code is "1111".
KX-T2378JXW 5.4. Dial Lock You can prevent others from making a call to any number except the one pre-programmed in the memory of the EMERGENCY button. Once you locked the dialing buttons, even emergency numbers cannot be dialed. Only incoming calls are accepted until the dial lock is canceled.
KX-T2378JXW 5.5. Call Restriction You can prevent the unit from dialing phone numbers beginning with specified digit(s) (1 digit or 2 digits). Phone numbers with the restricted leading digits cannot be dialed out. 5.5.1. To Set the Call Restriction Make sure that a call is not put on hold.
KX-T2378JXW 5.6. How to Release the Establishment of Dial Lock After this procedure, you will be able to establish a new password. How to release the establishment of dial lock.
KX-T2378JXW 6 DISASSEMBLY INSTRUCTIONS Shown in Fig —. To remove —. Remove —. Lower Cabinet Screws (2.6 × 12).........( A) × 5 Main P. C. Board The Main P.C. Board Battery Box The Battery Box Operational P.C. Board Screws (2.6 × 8)........(B) × 5...