Getting Started; Step 2: Setting Up The Remote Commander - Sony SLV-KF297MK2 Operating Instructions Manual

Step 2
Setting up the remote commander
Inserting the batteries
Insert two R6 (size AA) batteries by
matching the + and – on the batteries to
the diagram inside the battery
compartment.
Insert the negative (–) end first, then push
in and down until the position (+) end
clicks into position.
Using the remote commander
You can use this remote
commander to operate the unit
and a Sony TV. To operate this
unit, point at the remote sensor
on the unit. To operate the TV,
point at the remote sensor on
the TV.
To
Turn the TV to standby or active mode
Turn on the TV power
Increase (+) or decrease (–) the TV volume
Change the TV programme position
Select an input source of the TV either from aerial in or from line in
Notes
• With normal use, the batteries should last about three to six months.
• If you do not use the remote commander for an extended period of time, remove
the batteries to avoid possible damage from battery leakage.
• Do not use a new battery with an old one.
• Do not mix different types of batteries.
Remote sensor
REC
TV/VIDEO
; (TV power)
u
(on/standby)
PROG (CH) +/–
VOL +/–
Press
u (on/standby)
; (TV power)
VOL +/–
PROG (CH) +/–
TV/VIDEO

Getting Started

5