Table of Contents
Advertisement
Installation and Setup
When installing the K4815 in your modular system, pay close attention to the pinout and direction of
the 16-pin power input cable. The K4815 contains protection against reverse connection, but please
double-check the cable before switching on the unit. The warranty does not cover damage caused by
wrong installation.
Note:
Original K4815 modules required +5V in addition to +/-12V. Serial numbers 1009501 and higher
only require +/-12V. If you have an older model and wish to have it upgrade free of charge,
(parts and labour only) please contact Kilpatrick Audio directly for more information.
The K4815 Pattern Generator supports both MIDI and control voltage/gate/clock signals. To use the
MIDI function requires the use of a MIDI adaptor such as the K1600 MIDI Converter. But the K4815 can
be used by itself without any MIDI devices by using the analog inputs and outputs. If you are using the
module with another MIDI device using the internal MIDI cable, connect a 10 pin ribbon cable between
the two units. In this case also observe the correct cable direction.
Warning: DO NOT plug the MIDI cable into the power port, or vice versa.
User Manual
// K4815 // Pattern Generator
3p
Hardware Version D/E
Firmware Version 1.1x
February 16, 2011
© 2010 Kilpatrick Audio
Advertisement
Table of Contents
