Advertisement
O O - - r r i i n n g g M M a a i i n n t t e e n n a a n n c c e e
( ( c c o o n n t t . . ) )
O-ring removal illustrations: Figures A & B
F F i i g g u u r r e e A A
F F i i g g u u r r e e B B
Index Finger
H H o o u u s s i i n n g g C C o o n n t t r r o o l l s s
Back View
Focus/Macro
Switch
I
K
E
L
1
I
T
3
E
5 6 7
8
Made in
USA
Lanyard
[1] Power Button
[4] Video/Still Button
[5] Left Button
[2] Up Button
[6] Record Button
[3] Select Button
Index Finger
Thumb
O-ring
Squeeze Index Finger
and Thumb together
to form O-ring loop
Thumb
O-ring
5
Latch
2
4
10
9
[7] Right Button
[8] Delete Button
[9] Down Button
[10] Index Button
7
I I n n s s t t a a l l l l i i n n g g t t h h e e C C a a m m e e r r a a
Place the camera face down into the front housing ribs as shown.
C C l l o o s s i i n n g g t t h h e e H H o o u u s s i i n n g g
Rotate the hinged back onto the housing front. Close the latch
and make sure it locks. Latch will "click" into it's locked position.
Latch buttons will NOT be depressed when latch is properly
locked.
Latch in "locked" position
C C h h e e c c k k M M a a i i n n O O - - r r i i n n g g S S e e a a l l a a n n d d C C o o n n t t r r o o l l s s
Once the housing has been closed, look at the main housing o-ring
seal from the "top view" as seen on page #4. Rotate the housing
360 degrees and note the o-ring seal by looking through the clear
housing. A good seal should appear as a solid black line.
Make sure the housing controls line up with the camera controls.
T T u u r r n n C C a a m m e e r r a a O O n n
Turn the camera on and operate each of the housing controls to
get a feel for using the camera in the housing. Operate the camera
above water with the camera in the housing.
* * Y Y o o u u a a r r e e n n o o w w r r e e a a d d y y t t o o s s h h o o o o t t u u n n d d e e r r w w a a t t e e r r v v i i d d e e o o ! !
L L e e n n s s P P o o r r t t
Treat the glass in the lens port as a camera lens. After use, rinse
and gently dry the outside lens port to avoid water spotting. To
clean, use a mild soap solution or lens cleaner. Do not rinse the
inside port glass. Do not use alcohol or window cleaner on the Lens
Port.
U U R R - - P P r r o o F F i i l l t t e e r r
The included UR/Pro color correcting filter
for tropical blue water settings, replaces
some of the reds and warm natural tones
that would otherwise be lost underwater.
Effective in relatively shallow, sunny
conditions with or without a Video Light.
The #6441 .71 removable color filter is available separately for
use in green water settings.
N N O O T T E E : : Make sure no air bubbles are trapped between the UR-Pro
Filter and housing port. If so, remove the filter underwater,
wipe away the bubbles, and re-install filter on the housing port.
Latch Button
Latch Button
6
Housing
UR-Pro Filter
Port
8
Advertisement
