DF-50 DIFFUSION? HAZER
INTRODUCTION
The DF-50 Diffusion Hazer is the cleanest most cost effective atmospheric fogger available in the market today. Fluid
use is less than 2 ounces an hour! The Diffusion Haze produced is totally odorless and can only be detected visually.
No more sore throats or burning eyes. This patented machine utilizes a triple filtered system that breaks down the
Diffusion Fluid (food grade mineral oil) to a uniform 1-micron sized or less droplet. The unit is self-contained needing
only the proper power rating and a sufficient amount of fluid.
UNPACKING
Each DF-50 is carefully checked and tested to strict factory standards before being shipped. In each carton is the DF-
50 and accompanying power cord.
Warning: Do not connect the power cord to the unit and switch on until you have thoroughly read the operating
instructions section of this manual.
The DF-50 Diffusion Haze should NOT be considered as a standard haze machine. Because of the minute particulate
size of the haze produced and its long lasting hang time (3+ hours in an enclosed area) it is not necessary to have the
concentration of haze that is normally associated with other machines. The particles produced are so minute that they
are hardly visible to the eye. Although you make think the concentration is insufficient, you will find that after a very
short period of use the DF-50 will have produced more than a sufficient amount of atmosphere.
Due to the efficiency of the machine it is recommended that the machine be used intermittently, NOT continuously, and
in situations where the machine is not monitored by an operator, it is suggested you use a timer to switch the machine
ON and OFF. Under normal conditions you may find that a running time of 10 minutes ON each 15-20 minutes should
provide the desired atmosphere, however length of running time will vary for each job.
Another important factor in the operation of the DF-50 is that it should NOT be fully enclosed, unless enclosed in a
case approved by the manufacturer such as the one shown on Page 9. If the air temperature around the machine rises
too high the thermal sensor in the machine will turn it OFF. The machine works on the principle of drawing air from the
back of the machine and passing air through the machine, then out the front of the machine mixed with the diffusion
particles, which have gone through a triple filtration process. Therefore, a steady flow of cool air is recommended for
the machine, hence it is best operated in an unobstructed position.
http://www.reelefx.com/products/df50man.htm
DF-50 DIFFUSION HAZER
3/13/08 2:50 PM
Page 1 of 5
Need help?
Do you have a question about the DF-50 and is the answer not in the manual?
Questions and answers