Table of Contents
Advertisement
CONNECTIONS
3. The Left and Right
channel
RCA outputs
are labeled
on the
back panel.
The balanced
outputs
are not labeled.
The balanced
connector
closest
to the Left RCA output
is for the left
channel
output
and the connector
closest
to the RCA right
output
is the
right
balanced
output.
Care should be taken
to insure
that
the
channel
orientation
between
the Processor
and the high level
inputs
of your preamplifier
is maintained.
4. Connect
the digital
output
of your CD transport
and other
digital
sources
to the inputs
of the STUDIO 2. If you are using
multiple
digital
sources,
take
note of where each input
and
corresponding
switch setting
is located.
The STUDIO 2 is equipped with the following
inputs:
two coaxial,
one AT&T wide bandwidth fiber
optic,
standard
TOSH fiber
optic,
and one AES/EBU. All inputs
can accept
a signal
from any digital
source
such as Compact Disc players,
Laser Disc players,
DATs
or satellite
receivers.
When a powered digital
source is introduced
to an input
and that
input
is selected
with the specific
Input
switch,
the corresponding
signal
LED will
illuminate.
When the
source
and the
Processor
have locked
the SYNC indicator
LED
will illuminate.
The STUDIO 2 has a provision
to add an additional
AT&T input.
The second AT&T input
will
replace
the Coax 2 space on the back
panel and is selected
by the COAX2/ST input
switch.
For further
information
contact
KRELL.
NOTE: If the digital
source
is ON and the signal
LED does not
illuminate,
check to make sure the digital
interconnect
cable is
secure at both ends or is not in need of repair.
PAGE 8
Advertisement
Table of Contents
