Table of Contents
Advertisement
CONNECTIONS
INPUT AND OUTPUT CONNECTIONS
CAUTION: When making connections
to this
component or any
other,
make sure the power amplifier
is OFF and the preamplifier
is in the MUTE or STANDBY mode.
1. Connect the power cord to the back of the STUDIO 2 and plug
the unit into the wall AC receptacle.
2. Connect the STUDIO 2 analog output to the line level input of
your preamplifier.
The STUDIO 2 is equipped with two analog output configurations:
Single-ended
via RCA connectors
and balanced
via XLR connec-
tors.
If your preamplifier
has high level
balanced inputs,
we
recommend the balanced outputs of the Processor
be used. There
are considerable sonic benefits associated with the use of balanced
interconnection.
The XLR pin configuration
is described
below.
Pin 1
Pin 2
Pin 3
Ground
Non-inverting (0
°)
Inverting ( 180
°)
NOTE: The two outputs
can be used to simultaneously
feed
different
systems.
NOTE: If you decide to use the single-ended
analog outputs,
the
type of interconnect
cable should be chosen carefully.
High
quality
shielded cable is suggested.
PAGE 7
Advertisement
Table of Contents
