Raveon FireLine MURS band Technical Manual page 30

operation, the TOT setting is not changed.
RSSI (Receive Signal Strength Indicator) – Returns the
RS signal level of last received packet. This is DAC reading of
the RSSI in the radio. It is not calibrated, but gives a relative
signal strength indication.
SL Serial Number – Reads and returns a unique serial number
for thjs unit.
Show – Display the configuration of the modem. This will
SH
return a page of ASCII characters, showing the main
configuration parameters.
Save – Save all the parameters to EEPROM. This command
must be used if changed parameters are to be stored in non-
volatile memory, and used next time the modem is powered
SV up. Modem exits configuration mode after this command is
executed. It saves all parameters except the frequency (The
frequency is automatically saved when an ATFT, ATFR, or
ATFX command is executed)
Transmit Random Data – When issued, the modem will begin
TD
sending random data. Entering a <CR> will terminate the
transmission.
Max Packet Size – Set the maximum number of bytes in an
TT
over-the-air packet.
Read DC input Voltage– Returns the DC input voltage
VB
reading, in mV (12500 = 12.5VDC input).
Firmware Version – Returns firmware version currently
VR
loaded into the unit.
Restore Factory – Restore the factory default values. This
command will not erase the calibration values. After this
&F
command executes, the modem will still be in the CONFIG
mode.
** indicates values that are calibrated in the factory and are unit-specific. If the "Radio
Type" is changed, these will need to be re-calibrated.
Company Confidential
No parameters. Returns a
number 0-1024.
Read Only
1 - 999999999
0 = Go back to normal
1 = Random
2 = Hop up/dn one channel
3 = Force PLL to fast
4 = TX all 0s
5 = TX all 1s
6 = Test Points ON
7 = Transmit CW
8 = Transmit 1010101...
Read Only, 3
characters
30
none
unique
None
none
none None
240
1 - 512
none
None
none
none
Raveon Technologies Corp.