Set Temperatures; Temperature Curve; Run; After The Print Completes - Printrbot Simple Getting Started Manual

Set Temperatures

Next up , you need to set the extruder temp. Click on the Print Panel and scroll down to set the
temperatures (Extruder 195 for PLA and Heated bed 0) be sure to click the Set buttons. Also,
please note that you should now have a green connect button to indicate that you are
connected to your computer.

Temperature Curve

Now click on the Temperature Curve and watch the graph as the extruder and heat bed rise in
temp. You need to make sure that both of them reach the purple lines before proceeding to
the next step.

Run

Once the proper temperatures have been reached, you can then click on Run to start the print.
Please note that it may take several seconds (or longer) before your print actually begins. Once
it does start, the printer will move to home position (if it's not there already) and then begin to
print. The rst thing it will do is lay down a perimeter line around the area of your model and
then it will start the nal print.

After the print completes

The extruder and heat bed will turn off
automatically. Allow several minutes to cool
before you attempt to remove your print from
the bed. Please note that the prints can often be
rmly attached to the bed. To remove them, you
can slightly twist the print when pulling up as
this will help to break it free. You can also try to
leverage a thin object underneath the print to
pry it upward when lifting, but we recommend
caution with this approach as you don't want to
cut or damage the bed with a sharp object like
an Exacto blade, etc.
Congratulations, you have completed your rst 3D print on the Simple!
21