I-AMP GPT 60-IV User Manual page 15

The current output from the GPT 60-IV may be monitored with a good, high impedance multimeter
from the (-) Current Output terminal to ground. This multimeter should have an adequate frequency
response for this measurement, typically around 10kHz. The voltage reading will be proportional to
the following:
100mV RMS @ (-) Current Output = 0.74 AMPS Peak
LOOP OUTPUT FROM SCREW
TERMINAL CONNECTOR
WIRING DIAGRAM
HOT (+PHASE)
9. Input Connections: This Pheonix connector allows connection of all inputs:
unbalanced L/R connector at a nominal line level of –10dBV.
balanced line connection at a nominal line level of +4dBu.
microphone connection. Phantom power – 15V
~ 15 ~
G p t 6 0 - I v
HOT (-PHASE)
gpt
DESIGnS
mAnUFActurinG
Excellence Through Engineering