Commodore MPS 1000 User Manual page 29

Table
1-1.
DIP switch functions (Commodore mode).
SW Function ON OFF Factory
Setting
1· 1 Print Mode Selection IBM Commodore OFF
1-2 Device Select 5 4 OFF
1·3 Buzzer Mute Beep OFF
1-4 Controls Cut Sheet Feeder Valid Invalid OFF
1-5 NLQ/DRAFT Selection NLQ DRAFT
OFF
1-6 Page Length 12" 11 " OFF
1-7 Paper End Detector Inactive Active OFF
1-8 Uni-Directional Printing Valid Invalid OFF
NOTE: Printer is set for Commodore mode at the factory.
DIP switches are read at power-on reset.
If
DIP switch 1-1 is ON, the MPS 1000 is in its IBM mode. Table 1-2
applies to IBM mode.
Table
1-2.
DIP switch functions (IBM mode)
SW Function ON OFF Factory
Setting
1-1
Print Mode Selection 5152+ Commodore OFF
1·2
Character Graphic Select Table 2
Table1 OFF
1-3 Interface Serial Parallel
OFF
1-4 Controls Cut Sheet Feeder Valid Invalid
OFF
1-5 NLQ/DRAFT Selection NLQ DRAFT OFF
1-6 Page Length
12" 11" OFF
1-7 Paper End Detector Inactive Active OFF
1-8 Auto LF with CR Valid Invalid
OFF
·with DIP Switch 1-1 in the ON state (IBM mode) and DIP Switch 1-3 in the OFF
state (Centronics Parallel interface), DIP Switch 1-2 is CG Select rather than
Device Select. Note: Default is Table 1 if Commodore Serial Bus is selected with
IBM 5152+ Mode).
DIP switches are read at power-on reset.
23