Commodore MPS 1000 User Manual page 20

Loading Continuous Paper
Once your tractor is installed, you can load continuous paper. See
that the printer is turned off and open the front lid. Then move the
print head to the center of the printer. Pu11 the paper bail away from the
platen (the black roller) just as you did for single sheet loading. (Look at
Figure 1-7
if
you need to check on the names of any of these parts.)
Using Figure 1-13 as your guide, pu11 the locking levers forward so
that you can move the pin feed holders to the left and right. Put the left
holder approximately 3 I
4 of an inch from the extreme left position and
then push the locking lever back to lock that holder in place. Leave the
other holder unlocked.
Figure 1-13. Pin feed holder adjustment
Open the pin feed covers as shown in Figure 1-14 and feed the paper
under the paper separator and into the paper slot; push the paper
through until it comes up between the ribbon guide and the platen.
14