Table of Contents
Advertisement
HDMI Upgrade
Procedure
Figure 1
Showcase DVD
Back Panel
1
Hex screw
2
Access plate
2
Showcase DVD /
This product is manufactured in the United States of America. Krell
by Krell Industries, Inc., its subsidiaries, and authorized agents. HDMI, the HDMI logo, and High-Definition Multimedia Interface are trademarks
HDMI Upgrade
or registered trademarks of HDMI Licensing LLC. All other trademarks and trade names are registered to their respective companies.
© 2004 by Krell Industries, Inc., All rights reserved
Follow steps A – Z to install the HDMI board and related components into the Krell
Showcase DVD. You will need the following tools, not provided in the installation kit:
one 3/32 Allen wrench
one 1/4-inch nut driver
Make sure that the Showcase DVD is unplugged from AC power.
Steps A–D. Prepare the Showcase DVD For Installation
A. Remove the 12 T-15 Torx screws from the top cover of the Showcase DVD.
B. Set the cover aside.
C. Remove the two 440 7/16-inch hex screws (1) and nuts that secure the access
plate (2) on the back panel of the Showcase DVD (see Figure 1).
D. Set the hex screws, nuts, and access plate aside.
Steps E–I. Prepare the Progressive Output PCB and Analog Output
PCB For HDMI Upgrade.
E. Release the 22-pin, 7-inch flat digital video cable (3) from the locking socket (4)
on the progressive output PCB (see Figure 2).
To release a cable from a locking socket, pull the two tabs back, away from the
cable, at either end of the locking socket. To reset the locking socket, push the
tabs on the locking socket toward the cable.
F. Unscrew the 4-40 x 7/16-inch hex screw (5) from the pin standoff at MT1, on the
front left corner of the analog output PCB (see Figure 2 inset), and remove the
screw and its washer. Notice the MT1 through hole and the pin standoff below the
through hole (not illustrated). The pin standoff is attached to the chassis.
G. Turn the DVD Standard on its side to perform Steps H and I.
H. Insert and thread the supplied 4-40 x 3/4-inch screw through the bottom of the
chassis into the pin standoff. Notice that the screw protrudes up from the pin
standoff (not illustrated).
I. Thread the supplied 1-1/2-inch standoff onto the screw protruding through the
MT1 hole. (not illustrated).
one T-15 Torx wrench
one T-10 Torx wrench
1
2
®
is a registered trademark of Krell Industries, Inc., and is restricted for use
Advertisement
Table of Contents
