Tool Shop 241-9796 Operating Instructions Manual page 3

IMPORTANT SAFET Y INSTRUCTIONS
15. USE EYE PROTECTION. Use a full-face mask if the work you're doing
16. SECURE WORK. Use clamps or a vise to hold the work, this frees both
17. DON'T OVERREACH. Keep proper footing and balance at all times. Do not
18. MAINTAIN TOOLS. Keep tools sharp and clean for better and safer
19. AVOID UNINTENTIONAL STARTING. Be sure the switch is in the OFF position
20. ALWAYS CHECK AND MAKE SURE TO REMOVE ANY ADJUSTING KEYS
OR WRENCHES before turning the tool on. Left attached, these parts can fly
off a moving part and result in injury.
21. DO NOT USE THE TOOL IF IT CANNOT BE SWITCHED ON OR OFF.
22. DISCONNNECT THE PLUG FROM THE POWER SOURCE BEFORE MAKING
23. STAY ALERT. Watch what you are doing & use common sense. Don't operate
24. CHECK FOR DAMAGED PARTS. Before using this tool, any part that is
25. REPLACEMENT PARTS. When servicing, use only identical replacement
26. SERVICE AND REPAIRS should be made by qualified repair technicians at
an authorized repair center. Improperly repaired tools could cause serious
shock or injury.
SAFETY PRECAUTIONS FOR DETAIL SANDER
•
•
!
•
•
produces metal filings, dust or wood chips. Goggles are acceptable in other
situations. Wear a clean dust mask if the work involves creating a lot of fine
or coarse dust.
hands to operate the tool.
reach over or across machines that are running.
performance. Follow instructions for lubricating and changing accessories.
For safe performance. Keep handles dry, clean and free from oil and grease.
before plugging in.
Have your tool repaired before using it.
ANY ADJUSTMENTS. Changing attachments or accessories can be dangerous
if the tool could accidentally start.
any tool when you are tired.
damaged should be carefully checked to determine that it will operate properly
and perform its intended function. Check for alignment of moving parts,
binding of moving parts, breakage of parts, mountings, and other conditions
that may affect its operation. Inspect screws and tighten any ones that are
loose. Any part that is damaged should be properly repaired or replaced by
an authorized service center unless otherwise indicated elsewhere in the in-
struction manual. Have defective switches replaced by an authorized service
center. Don't use the tool if switch does not turn it on and off properly.
parts.
Do not put undue pressure on the sander such that it slows down.
After switching off, always wait until the sander has stopped before putting it
down.
Do not expose this tool to water or liquids. The abrasive pads, steel wool pad,
and polishing pad are not intended for wet use.
3